Specifications

Coverage: 1 - 3 m2/Kg	Thinning: no	Application: by brush	Application: by roller
Application: by knife	Initial bonding: 1 - 2 hours 20oC	Final bonding: 24 - 48 hours 20oC	Interior use
Application temperature: 10oC - 35oC	Cleaning: with water

Instructions for use

Substrate preparation

1. Before installation make sure that windows and doors have been fitted and that the building is weathertight.
2. Should be used at temperatures between 10^oC - 30^oC and relative humidity 40% - 50%. Do not use at temperatures below 10^oC.
3. The moisture content of the screed must be in accordance to the relevant standards.
4. If there is danger of rising damp, the application of a vapour barrier (EPOXITE DUR) is necessary before preparing the screed.
5. Wall and ceilings of the room must be completely dry.
6. Under floor heating system must operate for 2 weeks prior to wood floor installation.
7. The moisture content of the wood should be according to the wood flooring manufacturer’s requirements.

Cementitious screeds

1. Carefully check the substrate to verify that it is cured, dry, flat and mechanically strong.
2. Make sure that the surface is dry and clean from dust, paints, grease, oil residues, loose particles etc.
3. Apply PRIMER PU 900 for protection and strengthening of the surface.
4. Rough and uneven surfaces can be smoothed with self-leveling compounds. Installation of wood flooring must be carried out once the surface is completely cured and dry.
5. Screed laid onto lightweight concrete, or onto a concrete slab must be treated with a suitable vapour barrier (EPOXITE DUR)

Existing ceramic tiles, marble etc.

1. Make sure that the surface is dry and clean from dust, polish, paints, grease, oil residues, loose particles etc.
2. Carefully check the substrate to verify that tiles / marble are stably bonded.
3. The adhesion may be improved with the application of the specially formulated primer ADHESIL for glazed surfaces

Wooden flooring

1. Make sure that wooden planks are well bonded to the substrate.
2. Remove any varnish, paint or wax from the surface by abrasion or with paint and varnish remover STRIPP N CLEAN until the natural appearance of the wood is exposed.
3. Vacuum all dust and follow with wet cloth. When surface is completely dry proceed with the installation.

Application

1. Mix adhesive well before use.
2. Leave 1cm joint around the perimeter of the flooring and around columns and other interruptions. This gap will be covered after the installation with the skirting boards.
3. Apply the adhesive with a notched spatula for wood starting from one corner of the room.
4. Apply the adhesive to an area of approximately 1m².
5. Install the wooden plank on the adhesive and apply light pressure.
6. Install the next wood plank 3-5 cm away from the previous one and carefully slide it to its place.
7. Do not step on the newly bonded surface while adhesive is uncured because wooden boards may be moved from their position.
8. The floor is ready for light traffic the following day.
9. Polishing can be carried out within 5 days depending on ambient temperature. However it is recommended to wait for 7-8 days till the wooden parquet is completely set.